YI Smart Dash Camera Firmware Update

Device Requirement:

1. One Class10 80 MB/s reading speed micro SD card, 8-32 GB
2. One Windows PC
3. USB power source, can be USB charging port or portable USB battery kit, 1A Output

Update Instructions：

A. If YI Smart Dash Camera can boot normally

1. Download firmware.bin to the micro SD card and put it in the root directory (make sure the file name remains firmware.bin)
2. Insert the micro SD card in the camera
3. Connect the camera to a power source, then switch on the camera
4. A firmware update notice will pop up on the screen
5. Press the fourth button (Power and Setting) to update
6. Wait for 1-5 minutes before the update is successful and the camera is restarted

B. If YI Smart Dash Camera cannot boot normally, try push the reset button on the top of the camera with a pin. If the camera still cannot boot:

1. Download FWCARC10.bin to the micro SD card and put it in the root directory (make sure the file name remains FWCARC10.bin)
2. Insert the micro SD card in the camera
3. Connect the camera to a power source, then switch on the camera
4. The yellow light at the right-bottom corner of the camera will flash, but the screen remains dark (if the light is not flashing, push the reset button on the top of the camera with a pin)
5. Wait for 1-5 minutes before the update is successful and the camera is restarted
6. Format the micro SD card after the camera is successfully restarted, otherwise the update process will be started every time the camera is restarted